
Date: November 15th, 2025
Time: 8:00–4:30 PM (bring a lunch)
Location: The Mulch Center – 21457 Milwaukee Ave, Deerfield, IL 60015
CEUs: 8 available
Registration Deadline: October 27th, 2025
This is the skills-based part of the exam, and you will have 45 minutes to safely and successfully complete it. You must pass both the written and practical exams to obtain the certification. If you have been a participant in an ISA chapter, associate organization, or regional tree climbing championship or the International Tree Climbing Championship, you may waive the skills exam provided you satisfy all of the other requirements and complete all requirements noted on the Skills Exam Waiver Form.
The following informs the ISA Certified Tree Climber applicant of the requirements to pass the tree climbing practical (skills) test. It outlines in detail what you need to know, and which skills must be demonstrated during the test.
UNDERSTANDING THE EVALUATION FORM The evaluation form that is used to assess the applicant’s skills is designed to be as fair and objective as possible. Every attempt has been made to eliminate bias on the part of the evaluators. Every applicant will be judged by at least two trained evaluators. The skills to be demonstrated are outlined in specific task statements. Each task statement includes performance standards that indicate exactly what constitutes successful completion of the task. View the skills form. Each evaluator judges the candidate’s performance of each task to be either satisfactory or unsatisfactory. Candidates begin with 38 points. Points are deducted for each unsatisfactory performance of a task. The point deductions are proportional to the importance of the task. To pass the skills test, an applicant must have a minimum of 27 points. Certain tasks, determined to be skills that are critical to a tree climber’s competency. That means if a candidate fails to satisfactorily complete any critical tasks, they will fail the skills test.
PRE-CLIMB: INSPECTION OF EQUIPMENT The candidate must demonstrate a pre-climb inspection of their equipment. This includes a manual and visual inspection of the rope, safety lanyard, and climbing saddle for any defects which could pose a safety hazard. Defective equipment must not be used.
PRE-CLIMB: ON ROPE TEST Climbers demonstrate on rope test ascent and descent to the height of 6.5 feet (2 meters).
PRE-CLIMB: KNOTS AND HITCHES Climbers must demonstrate the tying of six additional knots within a one-minute-per-knot time limit. Four of these must be tied correctly to proceed to the main skills test. Each knot must be tied correctly on the first attempt in order to receive a satisfactory mark. The candidate must correctly dress and set each knot. When the candidate hands the knot to the evaluator, it is considered to be an attempt. The point deduction for failure to tie each knot successfully is 1 point. The following are the required knots: · Attaching hardware (i.e., girth hitch, cow hitch with a better half, timber hitch) · Termination knot (i.e., Buntline hitch, anchor hitch/anchor bend, double Fisherman’s bend/double fisherman’s knot) · End-line rigging termination knot (i.e., clove hitch with two halves, running bowline) · Rigging rope joining knot (i.e., sheet bend, quick hitch) · Midline knot (i.e., clove hitch, alpine butterfly knot) · Tree climbing friction hitch (i.e., tautline hitch, Blake’s hitch, Distel, Schwabisch, Valdotain Tresse [VT])
PRE-CLIMB: TREE AND SITE INSPECTION The climber must perform a tree and site inspection. The purpose is to check for: · The location of utilities and wires · In-ground targets · Above-ground targets · Tree structure and stability
ROPE THROW: CLIMBING LINE INSTALLATION The time allowed to perform the climb will start on the first throw. The climber must install the climbing rope at a predetermined position (20 to 25 feet [6 to 8 meters] above ground). The use of a throw weight is permitted, but the climber must successfully install the climbing line. A total of 15 attempts is the maximum permitted. If this task is not completed satisfactorily, the climber may not continue.
SECURED ENTRY: SECURED ENTRY INTO TREE The climbing rope must be installed in a manner that will permit a secured entry into the tree. Candidates must attach and configure industry-accepted mechanical rope work positioning devices or a friction hitch to a climbing line for ascent. Climbers MUST NEVER be in a position to fall for more than 3 feet (1 meter). A first warning is given, but a second offense will constitute failure at any point in the examination. Also, when applicable or required by local occupational and safety laws and regulations, a recognized friction hitch (e.g., tautline hitch, Blake’s hitch, Distel, Schwabisch, or French Prusik [VT]), must be tied for ascent. Additionally, a climber may have to be tied in securely with at least two secured systems (main rope and backup system).
ROPE ADVANCEMENT: AERIAL TREE INSPECTION Climbers must identify any structural defects, and potential hazards present on the tree (e.g., dead branches, lean, cracks, splits, excessive weight, wildlife). The climber must advance the climbing rope to the final tie-in position and may throw the rope as many times as necessary in this task. The use of a pole to reset the climbing line is permitted. Climbers are also permitted to climb the tree using safety lanyards. They must then ascend to the final, predetermined tie-in point using safe and accepted climbing techniques. The climber must remain tied in or secured at all times. If at any time the climber is not safely secured, they shall be instructed to tie in immediately and come down. This offense will constitute failure.
ROPE ADVANCEMENT: ASCEND TO FINAL, PREDETERMINED TIE-IN POINT The climber must tie in using a safe and appropriate manner within the maximum time limit set for the skills test. The purpose is not to introduce an element of speed into the exam, but rather to eliminate any candidate who is clearly not competent or prepared to do an efficient climb. The climber chooses the technique. The climber remains tied in at all times with a lanyard, the other end of a climbing rope, or a second climbing line.
TIE-IN: FINAL TIE-IN The climber should tie in with an industry-recognized friction hitch and stopper knot in the bitter end (running end) of the climbing line. Recognized friction hitches include: tautline hitch, Blake’s hitch, Distel, Schwabisch, or French Prusik (VT). The climber must be secured at all times. Failure to do so will result in termination of the exam.
HANDSAW CONTACT STATION: FIRST DESIGNATED WORKSTATION The climber must access the first designated workstation, demonstrate the controlled use of climbing rope and friction hitch while performing vertical and horizontal movements in the tree canopy. During completion of this task, climbers must be secured by at least two points of attachments (e.g., primary climbing rope and work positioning lanyard). Climbers must exhibit techniques to prevent uncontrolled swings. When applicable or required by local occupational and safety laws and regulations, a third point of attachment or contact with the tree may be required.
POLE SAW/PRUNER WORKSTATION: SECOND DESIGNATED WORKSTATION Climbers must move to the second designated workstation where they must contact the flag or bell with a pole saw or pole pruner while demonstrating controlled use of climbing rope, friction hitch or mechanical rope work positioning device. The pole must be requested and sent up from the ground.
DESCENT: DESCEND TO GROUND The climber must ensure sufficient rope to reach the ground. The climber pulls up the running end of the climbing rope AND shows a f igure-8 stopper knot. The climber should descend and land in a controlled manner at a safe speed without damaging the rope.
SKILLS EXAM TIME LIMIT The entire exam must be completed within 30 minutes to avoid point deductions. The maximum time allowed for the climb is 45 minutes.
APPLICATION SUBMISSION The first step in earning an ISA certification is submitting an application. An application can be submitted by those who believe they have met eligibility requirements for the program. If you are an ISA member and/or credential holder or if you have purchased any ISA products in the past, you have an online account with ISA. Simply log in at credentialing.isa-arbor.com and look for the ISA credential you are interested in applying for and click ‘Apply Now’ to start the process. Only fully completed applications can be submitted for review. Submitted applications will be reviewed within five (5) US business days. You will be notified by ISA of your application approval by email. If our team requires more information for approval, you will also be notified by email. You may review application status at any time through ISA’s credentialing management system. You will only be able to enroll for an examination once you have an approved application in the system for the program. ISA has the right to contact any person or organization as part of the review of your application. By applying, you authorize the release of any information requested by ISA for the purpose of reviewing your application. ISA has the right to notify appropriate organizations if your application contains false information.
EXAM ENROLLMENT Once your application has been approved, you will be eligible to enroll for an examination. The written portion of the exam is Computer-based and are offered through Pearson VUE testing centers. You can find the closest Pearson VUE testing center by visiting https://www.pearsonvue.com/isa/locate/ . Enrollment will include the processing of applicable exam fees. ISA does not provide refunds for exam enrollments. Onsite registration is not available for ISA exams, only candidates enrolled and confirmed for an examination will be able to sit for the exam on a given examination site, date, and location. For computer-based exams held through Pearson VUE, you will receive a 120-day authorization period to schedule and take the exam.
For the skills/practical components, each climber must bring gear meeting applicable ANSI/OSHA/CSA standards and in good repair.
I will bring climbing-style helmet; eye protection; work boots; climbing line; arborist saddle; self-closing/double-locking carabiners; work-positioning lanyard; handsaw with scabbard.
I understand carabiners used in fall-protection must meet locking-snap minimums and be designed to prevent unintentional opening.
I understand failure to meet these requirements may result in failure of the skills exam.
All personal protective equipment and fall protection, shall, at a minimum, satisfy local regulations and relevant standards (e.g., OSHA, and ANSI [for U.S.], CSA [for Canada]), or other relevant standards that apply in your jurisdiction. Rope snaps should be of the locking type. Carabiners used as part of the climber’s primary fall protection system must meet the minimum standards of rope snaps and be of a design such that they cannot unintentionally be opened during work operations. Failure to abide by these rules may result in the applicant’s failure of the skills examination.
I will arrive 30 minutes early with two IDs (one photo ID).
I understand no visitors, books, phones, food/beverages in the exam area, dress appropriately.
I agree to comply with all instructions from the exam administrator and all safety laws/standards.
I understand inappropriate conduct (cheating, disturbances, misuse of materials, etc.) may result in removal and/or invalidation of results.
Cancellation policy you must cancel at least two weeks before each class to receive a refund. Refunds will not include the credit card processing fees.
I have read and agree to the event’s cancellation/refund policy.